Pilot V6-3.5L (2004)
Power Window Control Module: Pinout Values and Diagnostic Parameters
Power Window Control Unit Input Test
Power Window Control Unit Input Test
1. Remove the driver's door panel, but leave the driver's door subharness connector connected to the driver's door wire harness.
2. Disconnect the 18P connector (A) from the power window control unit (B).
3. Inspect the connector and socket terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK, go to step 4.
