Pilot V6-3.5L (2004)
4. Disconnect and detach the connector (A) and harness clips (B) from the door.
5. Remove the bolts (C), and loosen the bolts (D), then remove the regulator (E) through the hole in the door.
6. Apply multipurpose grease to all the sliding surfaces of the regulator (A) where shown.
7. Install the glass and regulator in the reverse order of removal, and note these items:
-
Make sure the connectors are plugged in properly.
-
Roll the glass up and down to see if it moves freely without binding.
-
Make sure that there is no clearance between the glass and glass run channel when the glass is closed.
-
Adjust the position of the glass as necessary.
-
Do the power window control unit reset procedure.
-
Check for water leaks.
-
Test-drive and check for wind noise and rattles.
-
When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its perimeter.
