Pilot 2WD V6-3.5L (2006)
4. Remove the door panel (A) with as little bending as possible to avoid creasing or breaking it.
1. Remove the screws (B).
2. Release the clips (C) that hold the door panel with a commercially available trim pad remover (D).
3. Starting at the rear, pull the door panel upward, then release the lock knob (E).
5. Install the panel in the reverse order of removal, and note these items:
-
Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
-
Make sure the connector is plugged in properly and the rod is connected properly.
-
Push the clips into place securely.
-
Check the window and power door lock operations.
-
When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its outside perimeter to seal out water.
-
Check for water leaks.