Pilot 2WD V6-3.5L (2006)
Cowl Moulding / Trim: Service and Repair
Cowl Cover Replacement
1. Remove the windshield wiper arms.
2. Using a clip remover, detach the clips (A), then remove the front seal (B) and hood rear seal rubber (C). Take care not to scratch the cowl covers.
3. Detach the clips (D), and release the hooks (E, F) by carefully pulling the passenger's cowl cover (G) upward. Pull the hinge cover (H) out from
the front fender (I), and release the windshield washer tube (J), then remove the cover. Take care not to scratch the body.
4. Detach the clips (D), and release the hooks (K) by carefully pulling the driver's cowl cover (L) upward. Pull the hinge cover (M) out from the front
fender (N), then remove the cover. Take care not to scratch the body.
5. Install the covers in the reverse order of removal, and note these items:
-
Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
-
Push the clips into place securely.
