Pilot 2WD V6-3.5L (2006)
License Plate Frame: Service and Repair
Rear License Trim Replacement
NOTE: Put on gloves to protect your hands.
1. Remove the tailgate trim panel.
2. From inside the tailgate, remove the nuts securing the rear license trim (A), and disconnect the backup light connectors (B), rear view camera
connector (C).
3. From inside the tailgate, release the lower clips (A). Gently close the tailgate, and pull the rear license trim (B) out to detach the upper clip (C),
then remove the trim. Take care not to scratch the tailgate.
4. Install the trim in the reverse order of removal, and note these items:
-
Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
-
Make sure the back-up light connectors are plugged in properly.
-
Push the clips into place securely.
