Pilot 2WD V6-3.5L (2006)
Headliner: Service and Repair
Headliner Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program.
NOTE:
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
-
Take care not to bend and scratch the headliner.
-
Be careful not to damage the dashboard and other interior trim pieces.
1. Remove these items:
-
A-pillar trim, both sides
-
B-pillar lower trim, upper portion of both sides
-
B-pillar upper trim, both sides
-
D-pillar trim, both sides
-
Rear side trim panel, upper portion of both sides
-
C-pillar trim, both sides
2. Release the tabs (A) on both sides with a flat-tip screwdriver, then remove the sunvisor cap (B) from the bracket (C). Turn the cap, and remove it.
3. Remove the sunvisor (A) and holder (B) from both sides.
1. Remove the self-tapping ET screws.
2. Remove the sunvisor from the body and holder.