Pilot 2WD V6-3.5L (2006)
Trim Panel: Service and Repair
Trim Removal/Installation - Cargo Areas
Trim Removal/Installation - Cargo Area
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program.
NOTE:
-
Put on gloves to protect your hands.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
-
Take care not to bend or scratch the trim and panels.
1. Remove the trim as shown. To remove the cargo box, remove both rear side trim panels.
2. Install the trim in the reverse order of removal, and note these items:
-
Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
-
Push the clips into place securely.