Pilot 2WD V6-3.5L (2006)
(D). The projections (E) on the pin is broken during removal, so the clip must be replaced with a new one when the trim is reinstalled.
1. Remove these items:
-
Rear door opening trim, as needed.
-
Rear side trim panel, upper portion as needed.
2. Remove the upper anchor cap (A), and remove the upper anchor bolt (B).
3. Hit the upper clip in the D-pillar trim (A) with a rubber mallet. The clip is under the "SIDE CURTAIN AIRBAG" mark (B). Hitting the clip
breaks the projections (C) on the pin (D) and pushes it into the grommet (E) and against the body (F). The grommet becomes narrow.
NOTE: The clip must be replaced with a new when the D-pillar trim is reinstalled.
