Pilot 2WD V6-3.5L (2006)
Power Door Lock Actuator: Testing and Inspection
Door Lock Actuator Test
Door Lock Actuator Test
Driver's Door
1. Remove the driver's door panel.
2. Disconnect the 2P connector from the actuator.
3. Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only
momentarily.
4. If the actuator does not operate as specified, replace it.
Passenger's Door
1. Remove the passenger's door panel.
2. Disconnect the 2P connector from the actuator.
