Pilot 2WD V6-3.5L (2006)
Seat Cover: Service and Repair
Front Seat Cover
Front Seat Cover Replacement
-
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
-
The operation of the driver's seat position sensor must be checked after any of these actions.
-
Driver's seat position sensor replacement
-
Cover plate (front side of driver's seat slide rail) replacement
-
The ODS unit must be calibrated after any of the these actions:
-
Front passenger's seat replacement (including any seat components)
-
Replacement of the seat weight sensors
-
Replacement of the ODS unit
NOTE:
-
Seats with a side airbag have a "SIDE AIRBAG" label on the seat-back. Because the component parts (seat-back cover, cushion, etc.) of seats with
and without airbags are different, make sure you install only the correct replacement parts.
-
Do not repair any tears or frayed spots of the seat-back cover. If necessary, replace the seat-back cover.
-
Take care not to tear the seams or damage the seat covers.
-
On the passenger's seat, do not touch the OPDS sensor in the seat-back pad, and keep it away from oil. Oil can corrode the sensor causing it to fail.
-
Put on gloves to protect your hands.
Seat-back Cover
1. Remove the front seat.
2. Remove the head restraint.
3. Detach the clips by pulling on the bottom of the back panel (A) back, then pull the panel upward to release the hooks (B) from the seat-back frame,
and remove the panel.
4. For some driver's seats: Remove the clip (A), then remove the lumbar support knob (B).
