Pilot 2WD V6-3.5L (2006)
4. Remove the pad shims (A) and brake pads (B).
5. Remove the pad retainers (A).
6. Clean the caliper thoroughly; remove any rust, and check for grooves and cracks.
7. Check the brake disc for damage and cracks.
8. Clean and install the pad retainers.
9. Apply a thin coat of M-77 assembly paste (P/N 08798-9010) to the, pad side of outer pad shim C, inner pad shim A, both sides of inner pad shim
B, the back of brake pads (D), and the other areas indicated by the arrows. Wipe excess assembly paste off the shims and brake pads.
Contaminated brake discs or brake pads reduce stopping ability. Keep grease and assembly paste off the brake discs and brake pads.
10. Install the brake pads and pad shims correctly. Install the pad with the wear indicator (E) on the top inside. If you are reusing the brake pads,
always reinstall the brake pads in their original positions to prevent a momentary loss of braking efficiency.
