Pilot 2WD V6-3.5L (2006)
3. Remove the pad shims (A) and brake pads (B).
4. Remove the pad retainers (A).
5. Clean the caliper thoroughly; remove any rust, and check for grooves and cracks.
6. Check the brake disc/drum for damage cracks.
7. Clean and install the pad retainers.
8. Apply a thin coat of M-77 assembly paste (P/N 08798-9010) to the pad side of the shims (A), the back of brake pads (B), and the other areas
indicated by the arrows. Wipe excess assembly paste off the shims and pads. Contaminated brake discs or brake pads reduce stopping ability.
Keep grease and assembly paste off the brake discs and pads.
9. Install the brake pads and pad shims correctly. Install the brake pad with the wear indicator (C) on the inside. If you are reusing the brake pads,
always reinstall the brake pads in their original positions to prevent a momentary loss of braking efficiency.
