Pilot 2WD V6-3.5L (2006)
Brake Hose/Line: Service and Repair
Brake Hose Replacement
NOTE:
^
Before reassembling, check that all parts are free of dirt and other foreign particles.
^
Replace parts with new ones whenever specified to do so.
^
Do not spill brake fluid on the vehicle; it may damage the paint; if brake fluid gets on the paint, wash it off immediately with water.
^
To prevent the brake fluid from flowing, plug and cover the hose ends and joints with a shop towel or equivalent material.
1. Replace the brake hose (A) if the hose is twisted, cracked, or leaking.
2. Disconnect the brake hose from the brake line (B) using a 10 mm flare-nut wrench (C).
3. Remove and discard the brake hose clip (A) from the brake hose (B).
4. Remove the banjo bolt (C), and disconnect the brake hose from the caliper.
5. Remove the brake hose from the damper.
6. Install the brake hose (A) on the damper with flange bolt (B) first, then connect the brake hose to the caliper with the banjo bolt (C) and new
sealing washers (D).
