Pilot 2WD V6-3.5L (2006)
2. Install the crankshaft pulley and tighten the bolt. Do not use an impact wrench.
-
1
Hold the pulley with the holder handle (A) and holder attachment (B), then tighten the bolt to 64 Nm (6.5 kgf-m, 47 ft. lbs.) with a torque
wrench and a 19 mm socket (C).
-
2
Mark the bolt head (D) and crankshaft pulley (E) as shown, then tighten the bolt an additional 60° (The mark on the bolt head lines up
with the mark on the crankshaft pulley).
3. Install the drive belt.
4. Install the splash shield.
5. Install the right front wheel,
