Pilot 2WD V6-3.5L (2006)
NOTE:
-
Identify parts as they are removed so they can be reinstalled in their original locations.
-
Inspect the rocker shafts and rocker arms.
-
Rocker arms must be installed in the same positions if reused.
-
When removing or installing the rocker arm assembly, do not remove the mounting bolts. The bolts will keep the rocker arms, rocker shaft bridge,
and rocker shaft on the shaft.
-
If the rocker shaft does not remove or does not install by hand, remove or install the rocker shaft by heating the rocker shaft bridge.
-
Bundle the rocker arms with rubber bands to keep them together as a set, and remove the bands after the rocker arms have been installed.
-
Prior to reassembling, clean all the parts in solvent, dry them, and apply new engine oil to any contact points.
-
When replacing the rocker arm assembly, remove the fastening hardware from the new rocker arm assembly.
