Pilot 2WD V6-3.5L (2006)
10. Install the injector base (A). Always use a new gasket (B).
11. Apply new engine oil to the threads of the camshaft pulley mounting, bolt (A). Install the back cover (B), then install the camshaft pulley (C).
REAR
1. Loosen the valve adjusting screws.
2. Apply a light coat of new engine oil around the camshaft oil seal.
3. Gently tap the new camshaft oil seal (A) into the cylinder head.
-
1
Tap the camshaft oil seal in squarely.
-
2
Install the oil seal about 0.5 - 1.5 mm (0.02 - 0.06 inch) below the surface of the cylinder head.
4. Insert the camshaft (B) into the cylinder head, then install the camshaft thrust cover (C). Always use a new O-ring (D). Apply new engine oil to the
camshaft journals and lobes.
