Pilot 2WD V6-3.5L (2006)
Failed Part:
P/N 06141-RYP-305
H/C 8261265
Defect Code:
03214
Symptom Code:
04202
Template ID:
07-070A
Skill Level:
Repair Technician
Out of warranty:
Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Parts and Service Manager or your Zone
Office. You must request consideration, and get a decision, before starting work.
DIAGNOSIS
1.
Remove the intake manifold:
NOTE:
To save time, don't remove and plug the water (coolant) bypass hoses. Instead, unbolt the throttle body and move it to the side.
^
Refer to page 9-4 of the 2006-2008 Pilot Service Manual, or
^
Online, enter keyword MANIFOLD, and select Intake Manifold Removal and Installation from the list.
2.
Remove all the ignition coils:
^
Refer to page 4-19 of the service manual, or
^
Online, enter keyword COIL, and select Ignition Coil Removal/Installation from the list.
3.
Remove all the spark plugs:
^
Refer to page 4-22 of the service manual, or
^
Online, enter keyword SPARK, and select Spark Plug Inspection from the list.
4.
Remove the rear cylinder head cover:
^
Refer to page 6-83 of the service manual, or
^
Online, enter keyword CYLINDER, and select Cylinder Head Cover Removal (J35Z1) from the list.
5.
Attach a 19 mm wrench to the power steering pulley nut. Rotate the engine clockwise with the wrench until each rear bank cylinder goes past top
dead center (TDC). (This takes several complete engine revolutions.) While turning the engine, check to see if the intake and exhaust rocker arms
are opening and closing the valves at each cylinder.
^
If all the intake and exhaust rocker arms are opening and closing the valves, go to step 6.
^
If any of the intake or exhaust rocker arms are not opening and closing the valves, go to REPAIR PROCEDURE.