Pilot 2WD V6-3.5L (2006)
16.
Insert the four corner mounting bolts into the bridge, one at each rocker shaft end. If needed, slightly turn the shafts to allow the bolts to slide in.
NOTE:
Don't force the bolts. If a bolt won't slide in, the shaft may not be aligned, or it may be installed backward. The shafts are machined to allow
the bolts to easily pass through them.
17.
Clean off any sealer residue and oil from the rocker shaft holder. Also make sure the holder's mating surface on the cylinder head is clean.
18.
Apply Hondabond HT to the sealing surfaces between the rocker shaft holder and the cylinder head. Then slide the holder onto the end of the
bridge, and allow a few minutes for the Hondabond to set.
