Pilot 2WD V6-3.5L (2006)
7. Set the spark plug seals (A) on the spark plug tubes, and install the rear cylinder head cover (B).
NOTE:
-
Wait at least 30 minutes before filling the engine with oil.
-
Do not run the engine for at least 3 hours after installing the cylinder head cover.
8. Visually check the spark plug seals for damage.
9. Inspect the cover washers (C). Replace any washer that is damaged or deteriorated.
10. Tighten the bolts in two or three steps. In the final step tighten all bolts, in sequence, 12 Nm (1.2 kgf-m, 8.7 ft. lbs.).
11. Tighten the three bolts (A) securing the harness holder.
12. Install the breather hose (B) and ground cable (C).
13. Connect the three injector connectors, rocker arm oil control solenoid connector, and rocker arm oil pressure switch connector to the rear cylinder
head.
14. Install the three ignition coils from the rear cylinder head.
