Pilot 2WD V6-3.5L (2006)
4. Remove the evaporative emission (EVAP) canister hose (A) and the transmission breather hose clamp bracket (B).
5. Remove and plug the water bypass hoses (C).
6. Remove the engine wire harness connectors and wire harness clamps from the intake manifold.
-
Intake air temperature (IAT) sensor connector
-
Throttle actuator connector
-
Manifold absolute pressure (MAP) sensor connector
-
Evaporative emission (EVAP) canister purge valve connector
-
Intake manifold tuning (IMT) valve actuator connector (J35Z1 engine)
7. Remove the upper cover mounting bolts and nuts sequentially in two or three steps, then remove the upper cover.
8. Remove the intake manifold mounting bolts and nuts sequentially in two or three steps, then remove the intake manifold.
9. Remove the spacer (J35A9 engine).
Installation
1. Install the gaskets and spacer on the injector base (J35A9 engine).
