Pilot 2WD V6-3.5L (2006)
5. Install the positive crankcase ventilation (PCV) hose (A) and brake booster vacuum hose (B).
6. Connect the engine wire harness connectors, and install the wire harness clamps to the intake manifold.
-
Intake air temperature (IAT) sensor connector
-
Throttle actuator connector
-
Manifold absolute pressure (MAP) sensor connector
-
Evaporative emission (EVAP) canister purge valve connector
-
Intake manifold tuning (IMT) valve actuator connector (J35Z1 engine)
7. Install the intake air duct (A), then install the breather pipe (B).
8. Install the intake manifold cover.
9. Clean up any spilled engine coolant.
10. After installation, check that all tubes, hoses, and connectors are installed correctly.
11. Refill the radiator with engine coolant, and bleed air from the cooling system with heater valve open.
