Pilot 2WD V6-3.5L (2006)
Timing Belt: Service and Repair
Timing Belt Removal
Timing Belt Removal
1. Turn the crankshaft so its white mark (A) lines up with the pointer (B).
2. Check that the No. 1 piston top dead center (TDC) mark (A) on the front camshaft pulley and the pointer (B) on the front upper cover are aligned.
NOTE: If the marks are not aligned, rotate the crankshaft 360 degrees, and recheck the camshaft pulley mark.
3. Raise the vehicle on the hoist, then remove the right front wheel.
4. Remove the splash shield.
5. Remove the drive belt.
6. Support the engine with a jack and wood block under the oil pan.
