Pilot 2WD V6-3.5L (2006)
17. Install a new timing belt drive pulley (gear):
^ Refer to Section 6 of the appropriate service manual, or
^ Online, enter keywords TIMING BELT, and select Timing Belt Drive Pulley Replacement from the list.
18. Install a new timing belt:
NOTE:
Use the (new belt) Timing Belt Replacement Procedure, not the (used belt) Timing Belt Installation Procedure.
^ Refer to Section 6 of the appropriate service manual, or
^ Online, enter keywords TIMING BELT, and select Timing Belt Replacement from the list.
19. Reinstall the CKP sensor (if applicable), and torque its bolt to 9.8 Nm (7.2 lb-ft).
20. Reassemble the remaining parts using the appropriate service manual procedures. If you replaced the water pump, make sure you bleed any air from
the cooling system after refilling with the coolant you drained in step 1.
21. Do the CKP pattern clear/CKP pattern learn procedure. Go to the appropriate procedure below.
NOTE:
If you don't do the CKP pattern clear/learn procedure, the ECM/PCM may detect misfire when there is none, and possibly set DTC(s) P0300 through
P0306.
CKP Pattern Clear/Learn Procedure
2005-06 Odyssey
2005 Pilot
NOTE:
^ The ECT must be at least 176 degrees F (80 degrees C).
^ 2005 Pilot only: Before doing this procedure, check "PULSER F/B LEARN" and "PULSER F/B LEARN (HIGH RPM)" in the DATA LIST with the
HDS. If both values show N/A, this procedure is not needed.
^ 2005 Pilot only: If only "PULSER F/B LEARN (HIGH RPM)" shows N/A, skip steps 7 through 9.
1. With the engine stopped, clear the CKP pattern.
2. Turn the ignition switch to LOCK (0).
3. Turn the ignition switch to ON (II), and wait 30 seconds.
