Pilot 2WD V6-3.5L (2006)
13. Affected 2007 Accord V6 only: Replace the water pump, and reuse the coolant you removed in step 1:
^ Refer to page 10-5 of the 2003-07 Accord V6 Service Manual Supplement, or
^ Online, enter keyword WATER, and select Water Pump Replacement (V6 engine) from the list.
14. Affected 2007 Accord V6 only: Reinstall the timing belt adjuster.
15. Place the idler pulley shim between the idler pulley and the oil pump housing, and loosely install the idler pulley bolt with Hondalock 1 applied to its
threads. Make sure to follow the assembly instructions on the Hondalock 1 container.
NOTE:
The shim tapers from left to right. The word "OUT" is painted in white and stamped into the tang of the shim, and should be readable when the shim is
installed.
16. When tightening the idler pulley bolt, use the square end of a 1/4 inch drive ratchet exension to keep the shim's tab in the correct position. After you
torque the idler pulley bolt to 44 Nm (33 lb-ft), bend the shim's tab slightly towards the oil pump housing to keep it away from the idler pulley.
