Pilot 2WD V6-3.5L (2006)
4. Test-drive the vehicle on a level road: decelerate with the throttle fully closed from an engine speed of 2,500 rpm to 1,000 rpm with the A/T in 2.
5. Stop the vehicle, but keep the engine running.
6. Check PULSER F/B LEARN in the DATA LIST with the HDS. If it is NOT COMPLETED, go to step 4. If it is COMPLETED, go to step 7.
7. Test-drive the vehicle on a level road: decelerate with the throttle fully closed from an engine speed of 5,000 rpm to 3,000 rpm with the A/T in 2.
8. Stop the vehicle, but keep the engine running.
9. Check the PULSER F/B LEARN (HIGH RPM) in the DATA LIST with the HDS. If it is NOT COMPLETED, go to step 7. If it is COMPLETED, go
to step 10.
10. Turn the ignition switch to LOCK (0).
11. Turn the ignition switch to ON (II), and wait 30 seconds. The CKP learning procedure is complete.
2005-09 Accord
2007-09 Odyssey
2006-10 Pilot
2006-09 Ridgeline
1. Connect the HDS to the data link connector (DLC) located under the driver's side of the dashboard.
2. Turn the ignition switch to ON (II).
3. Make sure the HDS communicates with the ECM/PCM. If it does not, go to the DLC circuit troubleshooting.
4. Select CRANK PATTERN in the ADJUSTMENT MENU with the HDS.
5. Select CRANK PATTERN LEARNING with the HDS, and follow the screen prompts.
