Pilot 2WD V6-3.5L (2006)
5. If you feel too much or too little drag, loosen the locknut, and turn the adjusting screw until the drag on the feeler gauge is correct.
6. While holding the adjusting screw with the screw driver, tighten the locknut and recheck the clearance. Repeat the adjustment, if necessary.
Specified Torque
Front: 14 Nm (1.4 kgf-m, 10 ft. lbs.)
Apply new engine oil to the nut threads.
Rear: 20 Nm (2.0 kgf-m, 14 ft. lbs.)
7. Rotate the crankshaft clockwise, Align the pointer (A) on the front upper cover with the No. 4 piston TDC mark (B) on the front camshaft pulley.
8. Check and, if necessary, adjust the valve clearance on the No. 4 cylinder.
