Pilot 2WD V6-3.5L (2006)
Water Pump: Service and Repair
Water Passage Replacement
Water Passage Replacement
1. Drain the engine coolant.
2. Remove the intake manifold.
3. Remove the upper radiator hose (A) and lower radiator hose (B).
4. Remove the water bypass hose (A) and ground cable (B).
5. Remove the harness holder mounting bolt (C), then remove the harness holder (D) from the bracket.
6. Remove the heater hoses.
7. Remove the engine wire harness connectors from the water passage.
-
Engine coolant temperature (ECT) sensor 1 connector
-
Engine coolant temperature (ECT) sensor 2 connector
-
Exhaust gas recirculation (EGR) valve connector