Pilot 2WD V6-3.5L (2006)
14. Install the heater hoses.
15. Install harness holder (A) to the bracket, then tighten the mounting bolt (B).
16. Install the water bypass hose (C) and ground cable (D).
17. Install the upper radiator hose (A) and lower radiator hose (B).
18. Install the intake manifold.
19. After installation, check that all tubes, hoses and connectors are installed correctly.
20. Refill the radiator with engine coolant, then bleed air from the cooling system.
21. Clean up any spilled engine coolant.
