Pilot 2WD V6-3.5L (2006)
Air Door Actuator / Motor: Service and Repair
Heating/Air Conditioning
Air Mix Control Motor Replacement
Air Mix Control Motor Replacement
1. Disconnect the 7P connector (A) from the air mix control motor (B). Remove the rod (C) of the air mix control motor from the air mix control
linkage (D). Remove the self-tapping screws and the air mix control motor from the heater unit.
2. Install the motor in the reverse order of removal. Make sure the pin on the motor is properly engaged with the linkage. After installation, make
sure the motor runs smoothly.
Mode Control Motor Replacement
Mode Control Motor Replacement
1. Disconnect the 7P connector (A) from the mode control motor (B). Remove the rods (C) of the mode control motor from the mode control motor
linkage (D) and the mode control linkage (E). Remove the self-tapping screws and the mode control motor from the heater unit.
2. Install the motor in the reverse order of removal. After installation, make sure the motor runs smoothly.
Recirculation Control Motor Replacement
Recirculation Control Motor Replacement
1. Remove both glove box stops, then let the glove box hang down
2. Remove the wire harness connectors from the evaporator.
