Pilot 2WD V6-3.5L (2006)
3. Measure the voltage between the No. 1 terminal of the rear mode control motor 7P connector and body ground.
Is there battery voltage?
YES - Go to step 4.
NO - Repair open in the wire between the No. 3 fuse in the driver's under-dash fuse/relay box and the rear mode control motor.
4. Turn the ignition switch OFF.
5. Disconnect the rear mode control motor 7P connector.
6. Test the rear mode control motor.
Is the rear mode control motor OK?
YES - Go to step 7.
NO - Replace the rear mode control motor.
7. Disconnect climate control unit connector A (20P).
8. Check for continuity between the No. 11 and No. 12 terminals of climate control unit connector A (20P) and body ground individually.
Is there continuity?
YES - Repair any short to body ground in the wire(s) between the climate control unit and the rear mode control motor.
NO - Go to step 9.
