honda Workshop Repair Guides

Honda Workshop Service and Repair Manuals

Climate Control|Page 6437 > < Climate Control|Page 6435
Page 2
background image

Is there continuity?

YES - Repair any short to body ground in the wire(s) between the heater control panel and the recirculation control motor. 

NO - Go to step 9.

9. Turn the ignition switch ON (II), and check the same terminals for voltage.

Is there any voltage?

YES - Repair any short to power in the wire(s) between the heater control panel and the recirculation control motor. This short may also damage
the heater control panel. Repair the short to power before replacing the heater control panel.

NO - Go to step 10.

10. Turn the ignition switch OFF.

11. Check for continuity between the following terminals of the heater control panel 30P connector and the recirculation control motor 7P connector. 

Is there continuity?

YES - Check for loose wires or poor connections at the heater control panel 30P connector and at recirculation control motor 7P connector. If the
connections are good, substitute a known-good heater control panel, and recheck. If the symptom/indication goes away, replace the original heater
control panel. 

NO - Repair any open in the wire(s) between the heater control panel and the recirculation control motor.

Rear Mode Control Motor Circuit Troubleshooting

Rear Mode Control Motor Circuit Troubleshooting

1. Check the No. 3 (7.5 A) fuse in the driver's under-dash fuse/relay box.

Is the fuse OK?

Climate Control|Page 6437 > < Climate Control|Page 6435