Pilot 2WD V6-3.5L (2006)
G501.
9. Test the rear mode control motor.
Is the rear mode control motor OK?
YES - Go to step 10.
NO - Replace the rear mode control motor.
10. Check for continuity between body ground and rear heater-A/C control switch connector B (10P) terminals No. 1, 2, 3, 4, 5 and 6 individually.
Is there continuity?
YES - Repair any short to body ground in the wire(s) between the rear heater-A/C control switch and the mode control motor.
NO - Go to step 11.
11. Turn the ignition switch ON (II), and check the same terminals for voltage.
Is there any voltage?
YES - Repair any short to power in the wire(s) between the rear heater-A/C control switch and the mode control motor. This short may also
damage the rear heater-A/C control switch. Repair the short to power before replacing the rear heater-A/C control switch.
NO - Go to step 12.
12. Turn the ignition switch OFF.
