Pilot 2WD V6-3.5L (2006)
Blower Motor: Testing and Inspection
Rear Blower Motor Circuit Troubleshooting
1. Check the No. 55 (30 A) fuse in the under-hood fuse/relay box, and the No. 3 (7.5 A) fuse in the driver's under-dash fuse/relay box.
Are the fuses OK?
YES - Go to step 2.
NO - Replace the fuse(s), and recheck.
2. Turn the ignition switch ON (II).
3. Connect the No. 2 terminal of the rear blower motor 2P connector to body ground with a jumper wire.
Does the rear blower motor run?
YES - Go to step 4.
NO - Go to step 16.
4. Disconnect the jumper wire.
5. Disconnect the rear blower resistor 5P connector.
6. Connect the No. 3 terminal of the rear blower resistor 5P connector to body ground with a jumper wire.
Does the blower motor run?
YES - Go to step 7.
NO - Repair open in the wire between the rear blower motor and the rear blower resistor.
7. Disconnect the jumper wire.
8. Turn the ignition switch OFF.
