Pilot 2WD V6-3.5L (2006)
15. Check for continuity between the No. 7 terminal of rear heater-A/C control switch connector B (10P) and body ground.
Is there continuity?
YES - Test the rear heater-A/C control switch
NO - Check for an open in the wire between the rear heater-A/C control switch and body ground. If the wire is OK, check for poor ground at
G501.
16. Disconnect the jumper wire.
17. Disconnect the rear blower motor 2P connector.
18. Measure the voltage between the No. 1 terminal of the rear blower motor 2P connector and body ground.
Is there battery voltage?
YES - Replace the rear blower motor
NO - Go to step 19.
19. Turn the ignition switch OFF.
20. Remove the rear blower motor relay from the left side of rear heater-A/C unit, and test it.
Is the relay OK?
YES - Go to step 21.
NO - Replace the rear blower motor relay.
