Pilot 2WD V6-3.5L (2006)
9. Measure the voltage between the No. 23 terminal of the heater control panel 30P connector and body ground.
Is there about 5 V?
YES - Go to step 10.
NO - Repair open in the wire between the heater control panel and the A/C pressure switch.
10. Turn the ignition switch OFF.
11. Measure the resistance between the No. 19 and No. 27 terminals of the heater control panel 30P connector.
Is the resistance less than 24 KiloOhms?
YES - Check for loose wires or poor connections at the heater control panel 30P connector and at the A/C pressure switch 2P connector. If the
connections are good, substitute a known-good heater control panel, and recheck. If the symptom/indication goes away, replace the original heater
control panel.
NO - Repair cause of high resistance in the evaporator temperature circuit.
12. Turn the ignition switch OFF.
13. Disconnect the PCM connector A (44P).
