Pilot 2WD V6-3.5L (2006)
Driver/Vehicle Information Display: Testing and Inspection
Safety Indicator Input Test
Safety Indicator Input Test
1. Remove the gauge control module.
2. Disconnect the 36P connector B from the gauge control module.
3. Inspect the connector and socket terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK, go to step 4.
4. Reconnect the connectors to the gauge control module, and make the following input tests at the appropriate connector.
-
If any test indicates a problem, find and correct the cause, then recheck the system.
-
If all the input tests prove OK, go to step 5.