Pilot 2WD V6-3.5L (2006)
5. Reconnect the driver's multiplex control unit to the driver's under-dash fuse/relay box, and perform the following input tests at the appropriate
connectors on the driver's under-dash fuse/relay box. For driver's under-dash fusel relay box connector socket location.
-
If any test indicates a problem, find and correct the cause, then recheck the system.
-
If all the input tests prove OK, go to step 6.
Door Multiplex Control Unit
6. Remove the driver's door panel, and disconnect the connector A (20P) from the door multiplex control unit.
7. Inspect the connector and socket terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK, go to step 8.
8. Reconnect the connector to the door multiplex control unit, and make this input test.
-
If the test indicates a problem, find and correct the cause, then recheck the system.
-
If the input test proves OK, the driver's or door multiplex control unit must be faulty; replace with a known-good unit and retest.
