Pilot 2WD V6-3.5L (2006)
Auxiliary Power Outlet: Service and Repair
Front Accessory Power Socket
Front Accessory Power Socket Test/Replacement
1. Remove the center lower cover.
2. Disconnect the 2P connector from the front accessory power socket.
3. Inspect the connector terminals to be sure they are all making good contact.
-
If the terminals are bent, loose, or corroded, repair them as necessary, and recheck the socket.
-
If the terminals look OK, go to step 4.
4. Turn the ignition switch to ACC (I), and check for voltage between the No. 2 terminal and body ground. There should be battery voltage.
-
If there is battery voltage, go to step 5.
-
If there is no battery voltage, check for:
- Blown No. 8 (7.5 A) fuse in the driver's under- dash fuse/relay box.
- Blown No. 9 (15 A) fuse in the passenger's under-dash fuse/relay box.
- Faulty accessory power socket relay.
- Poor ground (G503, G651).
- An open in the wire.
5. Check for continuity between the No. 1 terminal and body ground. There should be continuity.
-
If there is continuity, go to step 6.
-
If there is no continuity, check for:
-
Poor ground (G503).
-
An open in the wire.
6. Remove the housing (A) and socket (B).
7. Install the power socket.in the reverse order of removal.
