Pilot 2WD V6-3.5L (2006)
1.
Fold the lead from the side marker down parallel with the wire harness. Starting about 1.5 inches down from the Y, wrap the lead and the harness
with electrical tape. Wrap the harness about 1.5 inches past the Y or to the clip. Wrap the harness tightly, and overlap the tape 50 percent on each
revolution.
2.
Repeat step 4 of DIAGNOSIS to check for leaks.
^
If there is no water entering the passenger compartment, go to step 3.
^
If there is still water entering the passenger compartment, continue with normal water leak troubleshooting.
3.
Reinstall all removed parts.
Disclaimer
