Pilot 2WD V6-3.5L (2006)
YES - Go to step 16.
NO - Go to step 10.
10. Turn the ignition switch OFF.
11. Jump the SCS line with the HDS.
12. Disconnect PCM connector A (44P).
13. Check for continuity between DLC terminal No. 7 and body ground.
Is there continuity?
YES - Repair short to ground in the wire between DLC terminal No. 7 and the PCM (A43). After repairing the wire, check for a DTC with the
HDS, and go to the indicated DTC's troubleshooting.
NO - Go to step 14.
14. Connect the DLC terminal No. 7 to body ground with a jumper wire.
15. Check for continuity between PCM connector terminal A43 and body ground.
Is there continuity?
YES - Update the PCM if it does not have the latest software, or substitute a known-good PCM, then recheck. If the symptom/indication goes
away with a known-good PCM, replace the original PCM.
