Pilot 2WD V6-3.5L (2006)
Failed Part:
P/N 37820-RYP-A61
Defect Code:
03214
Symptom Code:
03203
Skill Level:
Repair Technician
The warranty claim information below applies to adjusting the valves.
Operation Number:
11 03A3
Flat Rate Time:
2.1 hours
Failed Part:
P/N 14711-P8E-A00
Defect Code:
07406
Symptom Code:
03203
Skill Level:
Repair Technician
DIAGNOSIS
Inspect the Freeze Data or On Board Snapshot data using the HDS for DTCs P0300, P0301, P0302, P0303, P0304, P0305, or P0306.
Is the engine coolant temperature between 14 degrees F and 140 degrees F (-10 degrees C and 60 degrees C)?
Yes - Go to REPAIR PROCEDURE.
No - This service bulletin does not apply. Continue with normal troubleshooting.
REPAIR PROCEDURE
1. Adjust the valve clearance to the middle of the specification.
^
Refer to page 6-8 of the 2006-2008 Pilot Service Manual, or
Online, enter keywords VALVE CLEAR, and select Valve Clearance Adjustment (J35Z1 engine) from the list.
NOTE:
Make sure the cylinder head temperature is below 100 degrees F (38 degrees C) before doing the valve adjustment.
2. Update the PGM-FI software with the HDS. Refer to Service Bulletin 01-023, Updating Control Units/ Modules.
*3. Select CRANK PATTERN in the ADJUSTMENT MENU with the HDS.
4. Select CRANK (CKP) PATTERN CLEAR and follow the screen prompts.
5. Select CRANK (CKP) PATTERN LEARNING with the HDS, and follow the screen prompts.*
Disclaimer
