Pilot 2WD V6-3.5L (2006)
5. Disconnect the connectors (A).
6. Inspect the connector and socket terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK, go to step 7.
7. Make the given input tests at connector A (20P).
-
If any test indicates a problem, find and correct the cause, then recheck the system.
-
If all the input tests prove OK, go to step 8.
Driver's Unit
8. Remove the driver's multiplex control unit from the driver's under-dash fuse/relay box.
9. Inspect the connector and socket terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK, go to step 10.
