Pilot 2WD V6-3.5L (2006)
52. Connect PGM-FI main relay 1 (FI MAIN) 4P connector terminal No. 3 to body ground with a jumper wire.
53. Check for continuity between PCM connector terminal A6 and body ground.
Is there continuity?
YES - Test PGM-FI main relay 1 (FI MAIN). If the relay is OK, update the PCM if it does not have the latest software,or substitute a known-good
PCM, then recheck. If the symptom/indication goes away with a known-good PCM, replace the original PCM.
NO - Repair open in the wire between PGM-FI main relay 1 (FI MAIN) and the PCM (A6).
54. Reconnect PCM connector A (44P).
55. Turn the ignition switch ON (II).
56. Measure voltage between body ground and PCM connector terminal B3.
Is there battery voltage?
YES - Go to step 64.
NO - Go to step 57.
57. Turn the ignition switch OFF.
