Pilot 2WD V6-3.5L (2006)
Fuel Tank Unit: Service and Repair
Fuel Tank Unit Removal/Installation
Fuel Tank Unit Removal/Installation
Special Tools Required
Fuel sender wrench 07AAA-S0XA100
1. Relieve fuel pressure.
2. Remove the fuel fill cap.
3. Remove the driver's side second row seat.
4. Cut the wire harness under the carpet.
5. Remove the access panel (A) from the floor, then disconnect the fuel pump 5P connector (B).
6. Disconnect the quick-connect fitting from the fuel tank unit.
7. Using the tool, loosen the fuel tank unit locknut (A).
