Pilot 2WD V6-3.5L (2006)
Throttle Body: Service and Repair
Removal/Installation
Throttle Body Removal/Installation
CAUTION: Do not insert your fingers into the installed throttle body when you turn the ignition switch ON (II) or while the ignition switch is ON (II).
If you do, you will seriously injure your fingers if the throttle valve is activated.
NOTE: If you are replacing the throttle body, begin at step 1. If you are removing the throttle body temporarily, begin at step 4.
1. Connect the HDS while the engine is stopped.
2. Select the INSPECTION MENU with the HDS.
3. Do the TP POSITION CHECK in the ETCS TEST.
4. Disconnect the MAP sensor connector (A).
5. Remove the intake air duct (B).
6. Disconnect the throttle body connector (C).
7. Disconnect the water bypass hoses (D), and plug the water bypass hoses.
8. Remove the throttle body (E).
9. Clean the throttle body and intake manifold surface.
10. Install the parts in the reverse order of removal with a new gasket (F).
NOTE:
-
Do the PCM idle learn procedure.
-
Refill the radiator with engine coolant.
