Pilot 2WD V6-3.5L (2006)
Pressure Regulating Solenoid: Testing and Inspection
A/T Clutch Pressure Control Solenoid Valve A Test
A/T Clutch Pressure Control Solenoid Valve A Test
1. Connect the HDS to the DLC (A).
2. Choose Clutch Pressure Control (Linear) Solenoid A in Miscellaneous Test Menu on the HDS.
3. Test the A/T clutch pressure control solenoid valve A with the HDS.
^
If the valve tests OK, the test is complete. Disconnect the HDS.
^
If the valve does not test OK, follow the instructions on the HDS.
^
If the valve does not test OK, and the HDS does not determine the cause, go to step 4.
4. Get the customer's radio (and navigation) anti-theft codes, and write down the audio presets.
5. Disconnect the negative terminal from the battery, then disconnect the positive terminal.
6. Remove the battery hold-down bracket, and remove the battery and battery tray.
7. Remove the intake manifold cover and air intake duct.
8. Remove the battery base and battery base bracket.
9. Disconnect the A/T clutch pressure control solenoid valve A connector.
10. Measure the A/T clutch pressure control solenoid valve A resistance at the connector terminals.
Standard: 3 - 10 Ohms
^
If the resistance is out of standard, replace the A/T clutch pressure control solenoid valve A.
^
If the resistance is within the standard, go to step 11.
