Pilot 2WD V6-3.5L (2006)
8. With the passenger's multiplex control unit still disconnected, make these input tests at the connector and passenger's under-dash fuse/relay box
socket.
-
If any test indicates a problem, find and correct the cause, then recheck the system.
-
If all the input tests prove OK, go to step 9.
9. Reconnect the passenger's multiplex control unit to the passenger's under-dash fuse/relay box, and perform the input tests at the appropriate
connector of the passenger's under-dash fuse/relay box.
-
If any test indicates a problem, find and correct the cause, then recheck the system.
-
If all the input tests prove OK, go to step 10.
Door Multiplex Control Unit
10. Remove the driver's door pane and disconnect the 20P connector from the door multiplex control unit.
11. Inspect the connector and socket terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK, go to step 12.
12. Reconnect the connector to the door multiplex control unit, and make the input test at the connector.
