Pilot 2WD V6-3.5L (2006)
Air Bag: Service and Repair
Airbag Disposal
Airbag Disposal
Special Tools Required
Deployment tool 07HAZ-SG00500
Before scrapping any airbags, side airbags, or seat belt tensioners (including those in a whole vehicle to be scrapped), they must be deployed. If the
vehicle is still within the warranty period, the Honda District Parts and Service Manager must give approval and/or special instruction before deploying
the airbags, side airbags, or seat belt tensioners. Only after the airbags, side airbags, or seat belt tensioners have been deployed (as the result of vehicle
collision, for example), can they be scrapped. If the airbags, side airbags, or seat belt tensioners appear intact (not deployed), treat them with extreme
caution. Follow this procedure.
Deploying Airbags in the Vehicle
If an SRS equipped vehicle is to be entirely scrapped, its airbags, side airbags, or seat belt tensioners should be deployed while still in the vehicle. The
airbags, side airbags, or seat belt tensioners should not be considered as salvageable parts and should never be installed in another vehicle.
1. Turn the ignition switch OFF, then disconnect the negative cable from the battery, and wait at least 3 minutes.
2. Confirm that each airbag, side airbag, or seat belt tensioner is securely mounted.
3. Confirm that the deployment tool is functioning properly by following the check procedure on the tool label.
Driver's Airbag
4. Remove the access panel (A), then disconnect the 4P connector between the driver's airbag (B) and the cable reel (C).
Front Passenger's Airbag
5. Remove the glove box, then disconnect the 4P connector between the front passenger's airbag (A) and the dashboard wire harness (B).
Side Airbag
