Pilot 2WD V6-3.5L (2006)
10. Cut off each connector, strip the ends of the wires. Twist each pair of unlike colored wires together, and clip an alligator clip (A) to each pair.
Place the deployment tool at least 30 feet (10 meters) away from the vehicle.
NOTE: The driver's airbag and the front passenger's airbag each have four wires, two yellow and two red. Twist each pair of unlike colored wires
together, and connect an alligator clip to each pair.
11. Connect a 12 volt battery to the tool.
-
If the green light on the tool comes on, the igniter circuit is defective and cannot deploy the component. Go to Disposal of Damaged
Components.
-
If the red light on the tool comes on, the component is ready to be deployed.
12. Push the tool's deployment switch. The airbags and tensioners should deploy (deployment is both highly audible and visible: a loud noise and rapid
inflation of the bag, followed by slow deflation).
-
If the components deploy and the green light on the tool comes on, continue with this procedure.
-
If a component doesn't deploy, yet the green light comes ON, its igniter is defective. Go to Disposal of Damaged components.
-
During deployment, the airbags can become hot enough to burn you. Wait 30 minutes after deployment before touching the airbags.
