Pilot 2WD V6-3.5L (2006)
14. Place the weight on the front passenger's seat.
15. Drive the vehicle, accelerate to 20 mph (36 km/h), then stop on level ground.
16. From the HDS Main Menu, select SRS, then Seat Weight Sensor Misc Test, then Inspection. In the HDS Inspection Menu, select "SEAT
OUTPUT CHK." The weight (T1) of the front passenger's seat is recorded by the HDS.
17. Calculate the variance between the weight measured on the scale and the HDS with the formula.
Variance = (T1)-(M1) <±8.6 lbs (3.9 kg)
T1: Weight measured by the HDS with the weight on the seat
M1: Weight measured on the scale
-
If the variance is 8.6 lbs (±3.9 kg) or less, calibration is complete. Go to step 18.
-
If the variance is more than ±8.6 lbs (±3.9 kg), replace the front passenger's weight sensors (if they were not replaced before this procedure),
and repeat this procedure from the beginning.
18. Turn the ignition switch OFF, and disconnect the HDS from the DLC.
